Displays the configuration of the specified WAN PHY port.
|
port_list |
Specifies the port number. On a stand-alone switch, this value is just the port number, and on a modular switch, this value is the slot and port number. |
|
tag |
Specifies an 802.1Q or 802.1ad tag value. |
Real-time information.
Port number.
Link.
Framing.
Clocking.
Loopback.
Section trace.
Path trace.
If you do not specify a port number, range of ports, or tag value, the configuration is displayed for all WAN PHY ports. The default display is a constantly refreshing real-time display. If you specify the no-refresh parameter, the system displays a snapshot of the data at the time you issue the command.
The tag value may be associated with either a VMAN or a VLAN.
The following command displays the configuration for all LW XENPAK WAN PHY ports:
show ports wan-phy configuration
Following is sample output from this command:
WAN PHY Port Configuration Port Link Framing Clocking LoopBack SectionTrace PathTrace ================================================================ 1 A SONET Internal off abcdefghijklmn 01234567890 2 R SONET Internal Line abcdefghijklmn 01234567890 3R SONET Line off abcdefghijklmn 01234567890 4A SONET Internal Line abcdefghijklmn 01234567890 5R SONET Line off abcdefghijklmn 01234567890 6A SONET Internal Line abcdefghijklmn 01234567890 7R SDH Line Line abcdefghijklmn 01234567890 ================================================================
This command was available in ExtremeXOS 11.6.
The tag value was added in ExtremeXOS 12.4.4.
This command is available on all 10G XFP ports only on the Summit X480 series switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB