Enables the generation of an ICMP parameter-problem message on one or all VLANs.
| name | Specifies a VLAN name. |
Enabled.
Enables the generation of an ICMP parameter-problem message (type 12) when the switch cannot properly process the IP header or IP option information. If a VLAN is not specified, the command applies to all IP interfaces.
This command only affects the generation of certain ICMP packets. Filtering of ICMP packets usually forwarded by the switch is controlled by the access-list commands.
The following command enables the generation of an ICMP parameter-problem message on VLAN accounting:
enable icmp parameter-problem vlan accounting
This command was first available in ExtremeXOS 10.1.
This command is available on all platforms.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB