Show interface information for the given clock port that is added to the specified clock instance. This command is available only for boundary and ordinary clocks.
| boundary | Specifies boundary clock. |
| ordinary | Specifies ordinary clock. |
| vlan | VLAN. |
| vlan_name | VLAN name. |
| vlan all | All VLANs. |
N/A.
Use this command to display all the clock ports that have PTP enabled and added to the specified clock instance.
The following command displays PTP clock port interface information for all VLANs:
show network-clock ptp boundary vlan all VLAN Name : gm1-lpbk Acceptable Master Option : Disabled Unicast Negotiation : Disabled Port Type : Slave (forced) Log Announce Interval : 1 Log Announce Timeout : 3 Log Delay Request Interval : -6 Log Sync Interval : -6 VLAN Name : ptp-s1 Acceptable Master Option : Disabled Unicast Negotiation : Disabled Port Type : Master or Slave Log Announce Interval : 1 Log Announce Timeout : 3 Log Delay Request Interval : -6 Log Sync Interval : -6 VLAN Name : ptp-m1 Acceptable Master Option : Disabled Unicast Negotiation : Disabled Port Type : Master (forced) Log Announce Interval : 1 Log Announce Timeout : 3 Log Delay Request Interval : -6 Log Sync Interval : -6
This command was first available in ExtremeXOS 15.1.
This command is available on the cell site routers (E4G-200 and E4G-400) and Summit X770.
Note
PTP commands can be used only with the Network Timing feature pack.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB