unconfigure ports wan-phy

unconfigure ports [port_list | all] wan-phy

Description

Resets the configuration parameters of the specified WAN PHY port to default values.

Syntax Description

port_list

Specifies the port number. On a stand-alone switch, this value is just the port number, and on a modular switch, this value is the slot and port number.

all

Specified all WAN PHY ports.

Default

N/A.

Usage Guidelines

XFP ports must be in WAN PHY mode. To configure the mode, use the configure ports port_list mode {lan | wan-phy} command.

When the all option is used, the command constructs a port_list of all applicable ports—LW-XENPAK ports and/or XFP ports that have been WAN-PHY enabled.

The default configurable WAN PHY OAM parameters are as follows:
  • Framing—SONET.

  • Clock source—line.

  • Section trace—the IEEE default value, which has no string representation.

  • Path trace—the IEEE default value, which has no string representation.

  • Loopback—off.

Example

The following command unconfigures the configurable WAN PHY OAM parameters on a single LW XENPAK port on a modular switch:

unconfigure ports 2:1 wan-phy

History

This command was available in ExtremeXOS 11.6.

Platform Availability

This command is available on all 10G ports on 10G XFP ports only on the Summit X480 series switches.