show network-clock ptp boundary unicast-slave

show network-clock ptp boundary unicast-slave [{vlan} vlan_name | vlan all]

Description

Show the unicast slave table of the specified clock port, or all clock ports. This command is only available for boundary clocks.

Syntax Description

boundary Specifies the boundary clock.
unicast-slave Specifies table of unicast masters.
vlan VLAN.
vlan_name VLAN name.
vlan all Specifies all vlans.

Default

N/A.

Usage Guidelines

Use this command to display the unicast master table of the specified clock port or all clock ports. This command is only available for boundary clocks.

Example

The following command displays the unicast master table for all clock ports:

E4G-200.1 # show network-clock ptp boundary unicast-slave vlan all
VLAN Name                         IP Address
ptp-m1                            7.1.1.1
ptp-m1                            7.1.2.1
ptp-m1                            88.3.5.1

History

This command was first available in ExtremeXOS 15.1.

Platform Availability

This command is available on the cell site routers (E4G-200 and E4G-400) and Summit X770.

Note

Note

PTP commands can be used only with the Network Timing feature pack.