Enables Ethernet OAM on ports.
|
port_list |
Specifies the particular ports. |
|
all |
Specifies all fiber ports. |
Ethernet OAM is disabled on all ports.
Use this command to enable Ethernet OAM on one or more specified ports or on all fiber ports. Unidirectional link fault management is supported only on fiber ports.
Before enabling Ethernet OAM, autonegotiation must be turned off. The link should be a full duplex link.
If some ports cannot be enabled because, for instance, autonegotiation is not turned off, the command is executed for those ports that can be enabled and reasons for the failed ports are displayed.
To display the Ethernet OAM configuration, use the show ethernet oam command.
When operating as a stack master, the Summit X450e switch can process this command for ports on supported platforms.
The following command enables Ethernet OAM on all fiber ports:
enable ethernet oam ports all link-fault-management
This command was first available in ExtremeXOS 12.3.
This command is available on all platforms, except Summit X430 and Summit X440 - L2.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB