enable snmp traps port-up-down ports

enable snmp traps port-up-down ports [port_list | all]

Description

Enables port up/down trap reception for specified ports.

`port_list`	Specifies one or more ports or slots and ports.
all	Specifies all ports on the switch.

Enabled.

Use this command to begin receiving SNMP trap messages when a port transitions between being up and down.

The following command enables ports 3, 5, and 12 through 15 on a stand-alone switch to receive SNMP trap messages when the port goes up/down:

enable snmp traps port-up-down ports 3,5,12-15

This command was first available in ExtremeXOS 10.6.

This command is available on all platforms.

Published August 2016prev | next