configure tech-support collector frequency error-detected

configure tech-support collector [ all | hostname | ip_address] frequency [bootup [on | off] | error-detected [on | off]| daily [on {time hour} | off]]

Description

This command configures how often the switch sends status reports for a collector.

Syntax Description

all Configures report mode for all report collectors.
hostname Configures report mode based on the host name of the collector.
ip_address Configures report mode based on the IPv4 address of the collector.
bootup Send status report when the switch boots up. The default value is on.
on Specifies that the status reporting is on at bootup.
off Specifies that the status reporting is off at bootup.
error-detected Specifies that a status report is sent when a critical severity event is logged. The default value is off.
on Specifies that error-detected reporting is on.
off Specifies that error-detected reporting is off. This is the default value.
daily Specifies that status reports are sent once a day. The default value is off.
on time hour Specifies the time to send the report. Specifies the hour 0-23. The default value is 0 (12:00AM).
off Specifies that the daily status reports are off. This is the default value.

Default

Disabled.

Usage Guidelines

This command configures the frequency that the switch sends status reports for a collector. By specifying all, it configures report frequency for all existing collectors; otherwise it configures report frequency for a particular collector specified by the hostname or IP address. If the bootup option is set to on, the switch sends a status report when the switch boots up. If the error-detected option is set to on, the switch sends a status report when a critical severity event is logged. If the daily option is set to on, the switch sends a status report once a day regardless of the switchs' operational status during the last 24 hour period.

Optionally, you can specify the hour that the report is sent. The default hour is 0, and the valid range is 0 to 23, where 0 is 12:00 AM local time and 23 is 11:00 PM local time. You can enable or disable each option (bootup, error-detected or daily) independently. When all three options of a collector are turned off, the switch does not send any status report to that collector even if the report mode of the collector is set to automatic. When a collector is added, the bootup option is set to on, and the error-detected and daily option is set to off.

Example

The following command example configures the report mode on all existing collectors:

configure tech-support collector all report

History

This command was first available in ExtremeXOS 15.4.

Platform Availability

This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.