Displays the contents of the IPv6 routing table for routes with the specified origin.
direct | Specifies direct routes. |
auto-peering | Specifies BGP auto-peering routes. |
static | Specifies static routes. |
blackhole | Specifies blackhole routes. |
ripng | Specifies RIPng routes. |
ospfv3 | Specifies OSPFv3 routes. |
ospfv3-intra | Specifies OSPFv3 Intra routing. |
ospfv3-inter | Specifies OSPFv3 Inter routing. |
ospfv3-extern1 | Specifies OSPFv3 External 1 routing. |
ospfv3-extern2 | Specifies OSPFv3 External 2 routing. |
isis | Specifies IS-IS routes. |
isis-level-1 | Specifies IS-IS Level 1 routing. |
isis-level-2 | Specifies IS-IS Level 2 routing. |
isis-level-1-external | Specifies IS-IS Level 1 External routing. |
isis-level-2-external | Specifies IS-IS Level 2 External routing. |
bgp | Specifies Border Gateway Protocol. |
ibgp | Specifies Interior BGP route. |
ebgp | Specifies Exterior BGP route. |
bootp | Specifies BOOTP route. |
host-mobility | Specifies host-mobility routes. |
vr_name | Specifies a VR or VRF. |
N/A.
None.
The following example displays the RIPng routes:
show iproute ipv6 origin ripng
This command was first available in ExtremeXOS 11.2.
The bootp attribute was added in 15.7.1
The auto-peering option was added in ExtremeXOS 22.5.
This command is available on the platforms listed for the IPv6 unicast routing feature in the Switch Engine 32.2 Feature License Requirements document.