configure ports isolation

configure ports port_list isolation[on|off]

Description

Enables isolation mode on a per-port basis.

Syntax Description

port_list

Specifies one or more ports, or slots and ports.

isolation

Specifies that Isolated ports are not allowed to inter-communicate.

on

Turns on isolation. Isolated ports are not allowed to inter-communicate.

off

Turns off isolation. This is the default setting.

Default

Isolation is off by default.

Usage Guidelines

Use this command to enable isolation mode on a per-port basis. You can issue the command on a single port or on a master port of a load share group. If you issue the command on a non-master port of a load share group the command will fail. When a port load share group is formed, all of the member ports assume the same isolation setting as the master port.

Example

The following command enables isolation mode on ports 2 and 4 on a switch:

configure ports 1, 4 isolation on

History

This command was first available in ExtremeXOS 15.3.

Platform Availability

This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.