Configures the TCAM width of a switch.
| double | Specifies a double wide ACL TCAM. Provides double wide ACL key with additional qualifiers. |
| single | Specifies a single wide ACL TCAM. |
| slotNo | Specifies the slot to configure. |
| all | Specifies all slots. |
Single.
Note
This command is not applicable to the ExtremeSwitching X870 series switches. Key width is applied automatically on X870 switches.Use this feature to configure the width of the ACL TCAM key of a slot or switch to be either double wide or single wide.
The switch must be rebooted for the configuration change to take effect.
If you attempt to configure a double wide mode on a slot or switch that does not support it, an error message is displayed.
To display the configured mode, use the show access-list width command.
The following command configures slot 1 to use double wide mode:
# configure access-list width double slot 1
This command was first available in ExtremeXOS 12.5.
This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.