configure lldp ports vendor-specific dot3 mac-phy
Configures the LLDP port to advertise or not advertise MAC and physical layer capabilities to its neighbors. The capabilities include duplex and bit rate.
|all||Specifies all ports on the switch.|
|port_list||Specifies one or more ports or slots and ports.|
|advertise||Specifies to send the information to neighbors.|
|no-advertise||Specifies not to send the information to neighbors.|
When configured, the system advertises information about the speed capabilities, as well as autonegotiation support and status, of the LLDP port.
The following command configures all ports to advertise MAC/PHY capabilities to neighbors:
configure lldp ports all advertise vendor-specific dot3 mac-phy
This command was first available in ExtremeXOS 11.2.
This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.