Displays information about an OSPFv3 neighbor.
| ip_address | Specifies a neighbor router ID. |
| vlan_name | Specifies an IPv6 configured VLAN. |
| tunnel_name | Specifies an IPv6 tunnel. |
| detail | Specifies detail information. |
If no argument is specified, all OSPFv3 neighbors are displayed.
None.
The following command displays information about the OSPFv3 neighbors on the VLAN accounting:
show ospfv3 neighbor vlan accounting
The following three examples provide sample ouputs for show ospfv3 neighbor:
# show ospfv3 neighbor
Neighbor ID Pri State Up/Dead Time Interface InstanceID
BFD Session State
=========================================================================================
1.1.1.1 1 FULL /BDR 00:03:40:45/00:00:38 HQ_10_0_4 0
Active
# show ospfv3 neighbor detail
Neighbor 1.1.1.1, Interface address fe80::201:30ff:fe10:3ae6
In the area 0.0.0.0 via interface HQ_10_0_4
Neighbor priority is 1, State is FULL, 1338 events, 6 state changes
DR is 2.2.2.2 BDR is 1.1.1.1
Options is 0x13 (-|R|-|-|E|V6)
Neighbor is up for 00:03:42:17
Neighbor will be dead in 00:00:37
Retransmission queue length is 0
BFD Session State: Active
# show ospfv3 neighbor {vlan} <vlan-name>
Neighbor ID Pri State Up/Dead Time Interface InstanceID
BFD Session State
=========================================================================================
1.1.1.1 1 FULL /BDR 00:20:37:17/00:00:39 HQ_10_0_4 0
Active
3.3.3.3 1 FULL /DR 00:20:37:17/00:00:39 HQ_10_0_4 0
Active
4.4.4.4 1 2WAY /DOTHER 00:20:37:17/00:00:39 HQ_10_0_4 0
None
This command was first available in ExtremeXOS 11.2.
This command is available on platforms with Base license, or higher, as described in the Switch Engine 32.2 Feature License Requirements document.