Displays Flow Monitor group statistics information.
| group | Specifies the Flow Monitor group. |
| group_name | Specifies the assigned name of the Flow Monitor group. Range is 32 characters. |
| statistics | Specifies to show Flow Monitor information for all groups. |
| no-refresh | Specifies to show only one sample of the statistics and then exit the statistics display. |
| wide | Specifies to show a wider version of the display. |
N/A.
When group_name is entered, only the statistics for that group are shown. When not entered, all groups are shown using the Page Up and Page Down options.
Each group name is displayed along with the number of active flows, the number of flows that have aged out, the number of flows that were not learned because the group flow limit was exceeded, the number of flows learned on the group, and the number of flows that were not learned because the flow table was full.
When no-refresh is provided, the specified group or groups are displayed one time with their current values.
If no-refresh is not entered, the display is updated with refreshed values every five seconds. This display operates as a standard updatable Switch Engine statistics display, providing Page Up, Page Down, Exit, and Clear options.
When no-refresh is entered, the specified group or groups are displayed one time with their current values.
When wide is entered, a wider version of the display is shown. When wide is not entered, the counters are limited to a display width that fits into 80 display columns. When wide is provided, the full 64-bit counter value can be displayed (about 21 columns per integer value).
The following command shows statistics for a group with the name 'g1' with no-refresh specified:
# show flowmon gr g1 statistics no-refresh
Group Name Active Aged Out Flow Limit Learned Full Table State
Flows Flows Drops Flows Drops
-------------------- ---------- ---------- ---------- ---------- ---------- -----
g1 1 0 0 1 0 A
-----------------------------------------------------------------------------------
> in field indicates value exceeds column width. Use 'wide' option or '0' to clear.
State: A-Active, R-Ready, NR-Not Ready
This command was first available in ExtremeXOS 32.2.
This command is available on ExtremeSwitching 5520 and 5420 series switches.