Displays information about all the PVLANs on the switch.
This command has no arguments or variables.
N/A.
If the PVLAN is incomplete because it does not have a network or any subscriber VLAN configured, [INCOMPLETE] appears next to the PVLAN name.
The following example output displays all the PVLANs on the switch:
# show private-vlan -------------------------------------------------------------------------------------- Name VID Protocol Addr Flags Proto Ports Virtual Active router /Total -------------------------------------------------------------------------------------- Engineering Network VLAN: -Engr1 10 -------------------------------------- ANY 4 /5 VR-Default Non-Isolated Subscriber VLAN: -ni1 400 -------------------------------------- ANY 1 /1 VR-Default -ni2 401 ------------------------------------- ANY 1 /1 VR-Default Isolated Subscriber VLAN: -i1 500 ------------------------------------- ANY 1 /1 VR-Default Ops Network VLAN: -Ops 20 ------------------------------------- ANY 2 /2 VR-Default Non-Isolated Subscriber VLAN: -OpsNi1 901 ------------------------------------- ANY 1 /1 VR-Default -OpsNi2 902 ------------------------------------- ANY 1 /1 VR-Default -OpsNi3 903 ------------------------------------- ANY 1 /1 VR-Default -OpsNi4 904 ------------------------------------- ANY 1 /1 VR-Default Isolated Subscriber VLAN: -OpsI0 600 ------------------------------------- ANY 1 /1 VR-Default -OpsI1 601 ------------------------------------- ANY 1 /1 VR-Default -OpsI2 602 ------------------------------------- ANY 1 /1 VR-Default -OpsI3 603 ------------------------------------- ANY 1 /1 VR-Default -OpsI4 604 ------------------------------------- ANY 1 /1 VR-Default Sales [INCOMPLETE] Network VLAN: -NONE Non-Isolated Subscriber VLAN: -SalesNi1 701 ------------------------------------- ANY 1 /1 VR-Default -SalesNi2 702 ------------------------------------- ANY 1 /1 VR-Default Isolated Subscriber VLAN: -SalesI0 800 ------------------------------------- ANY 1 /1 VR-Default -------------------------------------------------------------------------------------- Flags : (C) EAPS Control vlan, (d) NetLogin Dynamically created VLAN, (D) VLAN Admin Disabled, (E) ESRP Enabled, (f) IP Forwarding Enabled, (i) ISIS Enabled, (I) IP Forwarding lpm-routing Enabled, (L) Loopback Enabled, (l) MPLS Enabled, (m) IPmc Forwarding Enabled, (n) IP Multinetting Enabled, (N) Network LogIn vlan, (o) OSPF Enabled, (p) PIM Enabled, (P) EAPS protected vlan, (r) RIP Enabled, (T) Member of STP Domain, (V) VPLS Enabled, (v) VRRP Enabled Total number of PVLAN(s) : 3
This command was first available in ExtremeXOS 12.1.
This command is available on all platforms that support the Private VLAN feature. For features and the platforms that support them, see the Switch Engine 32.2 Feature License Requirements document.