Unconfigures the sFlow collector.
|ipaddress||Specifies the IP address of the collector to reset.|
|udp-port-number||Specifies the UDP port.|
Specifies which virtual router.
Note: User-created VRs are supported only on the platforms listed for this feature in the Switch Engine 32.2 Feature License Requirements document.
This command allows you to reset the specified sFlow collector parameters to the default values.
Both the commands unconfigure ports monitor vlan and unconfigure sflow collector will reset the collector parameters to the default.
The following command removes the collector at IP address 192.168.57.1:
unconfigure sflow collector ipaddress 192.168.57.
This command was first available in ExtremeXOS 11.0.
This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.