This command displays the meters that are out-of-profile and the ports that have been disabled as a result of a meter that is out-of-profile. The show screen will display the out-of-profile status and rate-limit counters for both per-port and global meters. Both the per-port and global meter counters and status are an aggregate of the rule based counters and status which includes both ACL and dot1p rules. In addition a screen will display the global out-of-profile count for per-port meters. The global count is used for debugging systems that do not support per-port counters in the hardware. This global counter for per-port meters is an aggregate of the rule based counters which includes both ACL and dot1p rules.
| metername | Meter name. |
| disabled-ports | Show the meter out-of-profile status that resulted in disable-port action. |
| ports | Show the meter appllied to a specified port list. |
| portlist | Port list separated by a comma or - |
| port_group | Port group name. |
| global-count | Counter of all the rules (ACL and dot1p) using a per-port meter. |
N/A.
None.
#show meter out-of-profile ports ingMeterGrp Group: ingMeterGrp Ports: 4-5 Name Status Disabled Rate-Limit Counter Port ------------------------ -------------- -------- ------------------ ---- ingmeter1 Out of profile Yes 1234567 4 ingmeter1 Ok No 0 5 ingmeter2 Out of profile No 0 4 ingmeter2 Out of profile No 1467 5 ingmeter3 Out of profile No 0 4 ingmeter3 Ok No 0 5
This command was first available in ExtremeXOS 16.1.
This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.