show rip interface

show rip interface {detail}


Displays RIP-specific configuration and statistics for all VLANs.

Syntax Description


Specifies detailed display.


Show summary output for all interfaces.

Usage Guidelines

Summary includes the following information per interface:
  • VLAN name.
  • IP address and mask.
  • interface status.
  • packets transmitted.
  • packets received.
  • number of triggered updates.
  • cost.
Detail includes the following per interface:
  • VLAN name.
  • IP address and mask.
  • tx mode.
  • rx mode.
  • cost.
  • peer information (for each peer).
    • age.
    • version.
    • received packets.
    • received updates.
    • received bad packets.
    • received bad routes.
  • in policy.
  • out policy.
  • trusted gateway policy.
  • packets transmitted.
  • sent triggered updates.
  • packets received.
  • bad packets received.
  • bad routes received.


The following command displays the RIP configuration for all VLANS:

# show rip interface

The following is sample output from this command:

# show rip interface
VLAN       IP Address         Flags  Sent     Rcvd     Triggered Cost
Packets  Packets  Updates
Flags: (f) Interface Forwarding Enabled, (i) Interface RIP Enabled
(n) Multinetted VLAN, (r) Router RIP Enabled

The following command displays RIP-specific statistics for all VLANs:

# show rip interface detail


This command was first available in ExtremeXOS 10.1.

Platform Availability

This command is available on all platforms with a Base license or higher as described in the Switch Engine 32.2 Feature License Requirements document.