enable mpls rsvp-te lsp
Enables one or more RSVP-TE LSPs.
|lsp_name||Specifies the ingress LSP within the switch to be enabled.|
|all||Enables all RSVP-TE configured ingress LSPs.|
When an RSVP-TE LSP is enabled, the switch attempts to set up the LSP by signaling the destination by sending a path message using the assigned path and profile. By default, all newly created LSPs are enabled and can become active when the LSP has been configured. Note that an LSP must be configured with at least one path before it can be signaled.
The following command enables all RSVP-TE-configured LSPs:
enable mpls rsvp-te lsp all
This command was first available in ExtremeXOS 11.6.
This command is available only on the platforms that support MPLS as described in the Switch Engine 32.2 Feature License Requirements document.