configure vlan router-discovery other-config-flag
Description
Configures the other stateful configuration flag value sent in router discovery advertisements on the VLAN.
Syntax Description
vlan_name | Specifies an IPv6 configured VLAN. |
on_off | Specifies setting the flag to on or off. |
Default
Off.
Usage Guidelines
This command configures the contents of the other stateful configuration flag in the router advertisement messages.
When set to on, hosts use the administered (stateful) protocol (DHCP) for autoconfiguration of other (non-address) information. If this command is not entered, the default value is off.
Example
The following example configures the other stateful configuration flag to be on for the VLAN "top_floor":
configure vlan top_floor router-discovery other-config-flag on
History
This command was first available in ExtremeXOS 11.2.
Platform Availability
This command is available on the platforms listed for the IPv6 unicast routing feature in the Switch Engine 32.2 Feature License Requirements document.