configure snmpv3 add group user
Adds a user name (security name) to a group.
|hex_group_name||Specifies the group name to add or modify. The value is to be supplied as a colon separated string of hex octets.|
|group_name||Specifies the group name to add or modify in ASCII format.|
|hex_user_name||Specifies the user name to add or modify. The value to follow is to be supplies as a colon separated string of hex octets.|
|user_name||Specifies the user name to add or modify in ASCII format.|
|sec-model||Specifies the security model to use.|
|snmpv1||Specifies the SNMPv1 security model.|
|snmpv2c||Specifies the SNMPv2c security model.|
|usm||Specifies the SNMPv3 User-based Security Model (USM).|
|volatile||Specifies volatile storage.|
Use this command to associate a user name with a group.
As per the SNMPv3 RFC, a security name is model independent while a username is model dependent. For simplicity, both are assumed to be same here. User names and security names are handled the same. In other words, if a user is created with the user name username, the security name value is the same, username.
Every group is uniquely identified by a security name and security model. So the same security name can be associated to a group name but with different security models.
The following command associates the user userV1 to the group defaultRoGroup with SNMPv1 security:
configure snmpv3 add group defaultRoGroup user userV1 sec-model snmpv1
The following command associates the user userv3 with security model USM and storage type volatile to the access group defaultRoGroup:
configure snmpv3 add group defaultRoGroup user userV3 volatile
This command was first available in ExtremeXOS 10.1.
The hex_group_name and hex_user_name parameters were added in ExtremeXOS 11.0.
This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.