enable ripng

Description

Enables RIPng for the whole router.

This command has no arguments or variables.

Disabled.

Although RIPng is useful in small networks, it has a number of limitations that can cause problems in large networks, including:

A limit of 15 hops between the source and destination networks.
A large amount of bandwidth taken up by periodic broadcasts of the entire routing table.
Slow convergence.
Routing decisions based on hop count; no concept of link costs or delay.
Flat networks; no concept of areas or boundaries.

For larger networks, consider OSPFv3 as an alternative IGP.

The following command enables RIPng for the whole router:

enable ripng

This command was first available in ExtremeXOS 11.2.

This command is available on platforms with an Edge, Advanced Edge, or Core license. For licensing information, see the Switch Engine 32.2 Feature License Requirements document.