configure ospfv3 area normal
Configures an OSPFv3 area as a normal area.
|area_identifier||Specifies an OSPFv3 area, a four-byte, dotted decimal number.|
A normal area is an area that is not any of the following:
- Stub area
Virtual links can be configured through normal areas. External routes can be distributed into normal areas.
The following command configures an OSPFv3 area as a normal area:
configure ospfv3 area 10.1.0.0 normal
This command was first available in ExtremeXOS 11.2.
This command is available on platforms with Base license, or higher, as described in the Switch Engine 32.2 Feature License Requirements document.