show private-vlan name

show {private-vlan} name

Description

Displays information about the specified PVLAN.

Syntax Description


`name`	Specifies the name of the PVLAN to display.

Default

N/A.

Usage Guidelines

If the PVLAN is incomplete because it does not have a network or any subscriber VLAN configured, [INCOMPLETE] appears next to the PVLAN name.

Example

The following example output displays information for the companyx PVLAN:

# show private-vlan "Engineering"
--------------------------------------------------------------------------------------
Name            VID  Protocol Addr        Flags                Proto  Ports  Virtual
Active router
/Total
--------------------------------------------------------------------------------------
Engineering
Network VLAN:
-Engr1         10   --------------------------------------   ANY    4 /5   VR-Default
Non-Isolated Subscriber VLAN:
-ni1           400  --------------------------------------   ANY    1 /1   VR-Default
-ni2           401  -------------------------------------    ANY    1 /1   VR-Default
Isolated Subscriber VLAN:
-i1            500  -------------------------------------    ANY    1 /1   VR-Default
--------------------------------------------------------------------------------------
Flags : (C) EAPS Control vlan, (d) NetLogin Dynamically created VLAN,
(D) VLAN Admin Disabled, (E) ESRP Enabled, (f) IP Forwarding Enabled,
(i) ISIS Enabled, (I) IP Forwarding lpm-routing Enabled, (L) Loopback Enabled,
(l) MPLS Enabled, (m) IPmc Forwarding Enabled, (n) IP Multinetting Enabled,
(N) Network LogIn vlan, (o) OSPF Enabled, (p) PIM Enabled,
(P) EAPS protected vlan, (r) RIP Enabled,
(T) Member of STP Domain, (V) VPLS Enabled, (v) VRRP Enabled

History

This command was first available in ExtremeXOS 12.1.

Platform Availability

This command is available on all platforms that support the Private VLAN feature. For features and the platforms that support them, see the Switch Engine 32.2 Feature License Requirements document.