Enables and disables the topology change trap for all ports or edge ports only.
| stpd_name | Specifies an STPD name on the switch. |
| edge-ports | Specifies that topology change traps will be sent only for edge ports. |
| on | Enables the topology change trap. |
| off | Disables the topology change trap. |
By default, the topology change trap is disabled (off) for all ports.
You cannot enable the topology change trap for edge ports if you have disabled the topology change trap for all ports.
The following example disables the topology change trap for edge ports only in the STP domain r1.
configure stpd r1 trap topology-change edge-ports off
This command was first available in ExtremeXOS 15.7.1.
This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.