configure esrp add track-environment

configure esrp esrpDomain add track-environment failover priority


Configures an ESRP domain to track environmental failures.

Syntax Description

esrpDomain Specifies an ESRP domain name.
priority Specifies a number between 0 and 254. The default priority is 255. See the following "Usage Guidelines" section for more information.


No environmental tracking.

Usage Guidelines

Environmental tracking tracks power supply temperature status.

If a failure is detected, the ESRP domain priority steps to the failover-priority value specified. By setting the failover priority to be lower than the normal priority of the domain, it causes the affected domain to go into slave mode.

The range of the priority value is 0 to 254. Setting the priority to 255 configures the switch to slave mode, and to be ineligible to become the master. The switch remains in slave mode even when the VLAN fails over from the current master.

To make effective use of this feature, the normal priority of the ESRP domain must be higher than the failover priority of this command.


The following command enables environmental failure tracking, and specifies that the ESRP priority for ESRP domain esrp1 be set to 10 upon an environmental failure.

configure esrp esrp1 add track-environment failover 10


This command was first available in ExtremeXOS 11.0.

Platform Availability

This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.