configure l2vpn vpws peer static-pw
Changes the labels of a statically configured Ethernet pseudowire for a VPWS.
Specifies the VPWS for which you are configuring a peer.
Specifies the peer IP address.
Specifies the IP address of the peer node.
Specifies the static pseudowire.
Specifies the pseudowire transmit label.
Specifies the name of the egress label.
Specifies the static pseudowire receive label.
Specifies the name of the ingress label.
Use this command to change the labels of a statically configured Ethernet pseudowire for a VPWS that already exists. Either or both the outgoing (MPLS ingress) and incoming (MPLS egress) PW labels can be specified. The peer must be similarly configured with a static PW that has the reverse PW label mappings. Locally, the incoming_pw_label must be unique and is allocated out of the static label space. The outgoing_pw_label must match the peer‘s configured incoming PW label. The L2VPN can remain operational during the change; however, the PW goes down and comes back up.
The following command changes the VPWS label to "vpws1":
# configure l2vpn vpws vpws1 peer static-pw 188.8.131.52
This command was first available in ExtremeXOS 15.4.
This command is available on all platforms that support MPLS as described in the Switch Engine 32.2 Feature License Requirements document.