configure ospf area normal
Configures an OSFP area as a normal area.
|area-identifier||Specifies an OSPF area.|
A normal area is an area that is not any of the following:
- Stub area.
Virtual links can be configured through normal areas. External routes can be distributed into normal areas.
The following command configures an OSPF area as a normal area:
configure ospf area 10.1.0.0 normal
This command was first available in ExtremeXOS 10.1.
This command is available on platforms with Base license, or higher, as described in the Switch Engine 32.2 Feature License Requirements document.