Displays MPLS statistics for one or all Layer 2 VPNs.
| vpls_name | Specifies VPLS for which to display statistics. |
| vpws_name | Specifies VPWS for which to display statistics. |
| detail | Displays additional information about the Layer 2 VPNs. |
N/A.
None.
The following command displays statistics for all Layer 2 VPNs:
Switch.1 # show mpls statistics l2vpn VPN ID Peer IP RxPackets RxBytes TxPackets TxBytes ------------------------------------------------------------------------------- 99 11.100.100.219 32866 4967734 14005 2394407 11.100.100.218 398 8235 577 10583 2009 11.100.100.219 0 0 0 0 2008 11.100.100.219 0 0 15 688
The following command displays detailed statistics for all Layer 2 VPNs:
Switch.2 # (debug) 12.2 # show mpls statistics l2vpn detail VPNID (L2VPN Name) Peer IP State RxLabel TxLabel LSPTxLabel NextHopI/F RxPackets RxBytes TxPackets TxBytes ------------------------------------------------------------------------------- 99 (jwcvpls) 11.100.100.219 Up x80402 x80402 x00010 tordoze 32866 4967734 14005 2394407 11.100.100.218 Up x80407 x80405 x00011 tornext 398 8235 577 10583 2009 (pws-1) 11.100.100.219 Up x80403 x80403 x00010 tordoze 0 0 0 0 2008 (pws-2) 11.100.100.219 Up x80404 x80404 x00010 tordoze 0 0 15 688
L2VPN Name
Peer IP/LSP Flags RxPackets RxBytes TxPackets TxBytes
-----------------------------------------------------------------------
vpls1
1.1.1.1 U 0 0 0 0
lsp1 + 0 0
lsp2 + 0 0
Flags: (U) Up, (D) Down, (R) Ready, (S) Signaling, (+) In-use,
(-) Not In-use
This command was first available in ExtremeXOS 12.4.
This command is available only on the platforms that support MPLS as described in the Switch Engine 32.2 Feature License Requirements document.