configure policy maptable

configure policy maptable [response [tunnel | policy | both] | vlan_list profile_index]


Use this command to add entries to the mapping table and to set the map table response state for the switch.

Syntax Description

vlan_list VLAN ID or range of IDs (1–4,094)
profile_index Policy ID (1–63).
response Indicates which attributes to use from RADIUS response.
tunnel Applies the VLAN-tunnel attribute. VLAN/NSI mappings from RADIUS are used if present. Mappings in policy profile are ignored.
policy Applies the policy specified in the filter-ID. VLAN/NSI mappings from policy profile are used if present. Mappings in RADIUS response are ignored.

An enhanced policy option that applies either all the filter-ID and VLAN tunnel attributes or the policy depending upon whether one or both are present.

VLAN/NSI mappings from either RADIUS or policy profile may be used. Mappings in RADIUS response have a higher precedence over policy profile when both contain mappings.



Usage Guidelines

The policy response is the default response for the configure policy maptable command.


This example adds an entry to the map table that maps VLAN 3 to policy profile 8:

configure policy maptable 3 8


This command was first available in ExtremeXOS 16.1.

Platform Availability

This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.