enable cfm segment frame-loss measurement mep
If the user specifies the mode as continuous, the LMM transmission will continue till it is stopped by the user.enable cfm segment frame-loss measurement segment_name mep mep_id [continuous | count frames]
This command is used to trigger LMM frames at the configured transmit-interval.
|segment_name||An alpha numeric string identifying the segment name.|
|continuous||Specifies that frames are to be sent continuously until stopped.|
|count||Specifies that a number of frames are to be sent.|
|frames||Specifies the number of frames to send. The range is 1 to 4294967295.|
This command is used to trigger LMM frames at the configured transmit-interval. If the user specifies the mode as continuous, the LMM transmission will continue till it is stopped by the user.
NoteIf the user tries to trigger the LMM frames for a segment which is not completely configured, the frames will not be transmitted for that segment, and an error message will be thrown.
enable cfm segment cs2 frame-loss measurement mep 3 count 10 enable cfm segment cs2 frame-loss measurement mep 3 continuous
This command was first available in ExtremeXOS 15.1.
This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.