Use this command to display the IPSG configurations on all ports.
Format | show ip verify source |
Mode |
|
Interface | Interface address in unit/slot/port format. |
Filter Type | Is one of two values:
|
IP Address | IP address of the interface |
MAC Address | If MAC address filtering is not configured on the interface, the MAC Address field is empty. If port security is disabled on the interface, then the MAC Address field displays “permit-all.” |
VLAN | The VLAN for the binding rule. |
The following example shows CLI display output for the command.
(Extreme 220) #show ip verify source
Interface Filter Type IP Address MAC Address Vlan
--------- ----------- --------------- ----------------- -----
0/1 ip-mac 210.1.1.3 00:02:B3:06:60:80 10
0/1 ip-mac 210.1.1.4 00:0F:FE:00:13:04 10