Preface
Using the Command-Line Interface
Stacking Commands
Management Commands
Utility Commands
Switching Commands
Routing Commands
IPv6 Management Commands
Quality of Service Commands
Application Commands
200 Series Log Messages
- Core
- Utilities
- Management
- Switching
- QoS
- Routing/IPv6 Routing
- Stacking
- Technologies
- O/S Support

username snmpv3 accessmode

This command specifies the SNMPv3 access privileges for the specified login user. The valid accessmode values are readonly or readwrite. The username is the login user name for which the specified access mode applies. The default is readwrite for the “admin” user and readonly for all other users.

Note

You must enter the username in the same case you used when you added the user. To see the case of the username, enter the show users command.

Defaults	admin - readwrite other - readonly
Format	username snmpv3 accessmode username {readonly \| readwrite}
Mode	Global Config

Published February 2019prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback