show auto-voip

Use this command to display the auto VoIP settings on the interface or interfaces of the switch.

Format	show auto-voip {protocol-based\|oui-based} interface {unit/slot/port\|all}
Mode	Privileged EXEC

Column

Meaning

VoIP VLAN ID	The global VoIP VLAN ID.
Prioritization Type	The type of prioritization used on voice traffic.
Class Value	If the Prioritization Type is configured as traffic-class, then this value is the queue value. If the Prioritization Type is configured as remark, then this value is 802.1p priority used to remark the voice traffic.
Priority	The 802.1p priority. This field is valid for OUI auto VoIP.
AutoVoIP Mode	The Auto VoIP mode on the interface.

The following example shows CLI display output for the command.

(Extreme 220) (Routing)# show auto-voip protocol-based interface all
VoIP VLAN Id................................... 2
Prioritization Type............................ traffic-class
Class Value....................................   7
Interface  				Auto VoIP			Operational Status
                  Mode
---------    -------------- -----------------
0/1           Disabled       Down
0/2           Disabled       Down
0/3           Disabled       Down
0/4           Disabled       Down

The following example shows CLI display output for the command.

(Extreme 220) (Routing)# show auto-voip oui-based interface all
VoIP VLAN Id................................... 2
Priority....................................... 7
Interface   Auto VoIP   Operational Status
				Mode
---------  -------------- ------------------
0/1        Disabled       Down
0/2        Disabled       Down
0/3        Disabled       Down
0/4        Disabled       Down
0/5        Disabled       Down

Published February 2019prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback