switch renumber

This command changes the switch identifier for a switch in the stack. The oldunit is the current switch identifier on the switch whose identifier is to be changed. The newunit is the updated value of the switch identifier. Upon execution, the switch will be configured with the configuration information for the new switch, if any. The old switch configuration information will be retained, however the old switch will be operationally unplugged. This command is executed on the Primary Management Unit.

Note

Note

If the management unit is renumbered, then the running configuration is no longer applied (that is, the stack acts as if the configuration had been cleared).
Format switch oldunit renumber newunit
Mode Global Config