show trapflags
This command displays trap
conditions. The
command‘s display shows all the enabled OSPFv2 and OSPFv3 (Open Shortest Path First version 3) trapflags. Configure which
traps the switch should generate by enabling or disabling the trap condition. If a trap
condition is enabled and the condition is detected, the SNMP (Simple Network Management Protocol) agent on the switch sends the trap
to all enabled trap receivers. You do not have to reboot the switch to implement the
changes. Cold and warm start traps are always generated and cannot be disabled.
| Format |
show trapflags |
| Mode |
Privileged EXEC |
Column
Meaning
| Authentication Flag |
Can be
enabled or disabled. The factory default is enabled. Whether authentication
failure traps will be sent. |
| Link Up/Down Flag |
Can be
enabled or disabled. The factory default is enabled. Whether link status traps
will be sent. |
| Multiple Users Flag |
Can be
enabled or disabled. The factory default is enabled. Whether a trap will be sent
when the same user ID is logged into the switch more than once at the same time
(either through Telnet or the serial port). |
| Spanning Tree Flag |
Can be
enabled or disabled. The factory default is enabled. Whether spanning tree traps
are sent. |
| ACL
Traps |
May be
enabled or disabled. The factory default is disabled. Whether ACL traps are
sent. |
| BGP4 Traps |
Can be
enabled or disabled. The factory default is disabled. Whether BGP4 traps are sent.
(This field appears only on systems with the BGPv4 software package
installed.) |
| DVMRP Traps |
Can be
enabled or disabled. The factory default is disabled. Whether DVMRP traps are
sent. |
| OSPFv2 Traps |
Can be
enabled or disabled. The factory default is disabled. Whether OSPF traps are sent.
If any of the OSPF trap flags are not enabled, then the command displays disabled. Otherwise, the
command shows all the enabled OSPF traps‘ information. |
| OSPFv3 Traps |
Can be
enabled or disabled. The factory default is disabled. Whether OSPF traps are sent.
If any of the OSPFv3 trap flags are not enabled, then the command displays
disabled. Otherwise, the
command shows all the enabled OSPFv3 traps‘ information. |
| PIM Traps |
Can be
enabled or disabled. The factory default is disabled. Whether PIM traps are
sent. |
Print
this page
Email this topic
Feedback
View PDF
Download EPUB