sflow source-interface
Use this command to specify the physical or logical interface to use as the sFlow client source interface. If configured, the address of source Interface is used for all sFlow communications between the sFlow receiver and the sFlow client. Otherwise there is no change in behavior. If the configured interface is down, the sFlow client falls back to normal behavior.
| Format |
sflow source-interface {unit/slot/port |
loopback
loopback-id | tunnel
tunnel-id | vlan
vlan-id} |
| Mode |
Global Config |
| Parameter |
Description |
| unit/slot/port |
VLAN or port-based routing interface. |
| loopback-id |
Configures the loopback interface to use as the source IP address. The range of the loopback ID is 0 to 7. |
| tunnel-id |
Configures the tunnel interface to use as the source IP address. The range of the tunnel ID is 0 to 7. |
| vlan-id |
Configures the VLAN interface to use as the source IP address. The range of the VLAN ID is 1 to 4093. |
Print
this page
Email this topic
Feedback
View PDF
Download EPUB