Preface
Using the Command-Line Interface
Stacking Commands
Management Commands
Utility Commands
Switching Commands
Routing Commands
IPv6 Management Commands
Quality of Service Commands
Application Commands
200 Series Log Messages
- Core
- Utilities
- Management
- Switching
- QoS
- Routing/IPv6 Routing
- Stacking
- Technologies
- O/S Support

username snmpv3 authentication

This command specifies the authentication protocol to be used for the specified user. The valid authentication protocols are none, md5 or sha. If you specify md5 or sha, the login password is also used as the SNMPv3 authentication password and therefore must be at least eight characters in length. The username is the user name associated with the authentication protocol.

Note

You must enter the username in the same case you used when you added the user. To see the case of the username, enter the show users command.

Default	no authentication
Format	username snmpv3 authentication username {none \| md5 \| sha}
Mode	Global Config

Published February 2019prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback