Use this command to show the DHCP (Dynamic Host Configuration Protocol) Snooping status of the interfaces.
Format | show ip dhcp snooping interfaces |
Mode | Privileged EXEC |
The following example shows CLI display output for the command.
(Extreme 220) #show ip dhcp snooping interfaces Interface Trust State Rate Limit Burst Interval (pps) (seconds) ----------- ---------- ---------- -------------- 1/g1 No 15 1 1/g2 No 15 1 1/g3 No 15 1 (Extreme 220) #show ip dhcp snooping interfaces ethernet 1/g15 Interface Trust State Rate Limit Burst Interval (pps) (seconds) ----------- ---------- ---------- -------------- 1/g15 Yes 15 1