Preface
Using the Command-Line Interface
Stacking Commands
Management Commands
Utility Commands
Switching Commands
Routing Commands
IPv6 Management Commands
Quality of Service Commands
Application Commands
200 Series Log Messages
- Core
- Utilities
- Management
- Switching
- QoS
- Routing/IPv6 Routing
- Stacking
- Technologies
- O/S Support

snmp-server enable traps fip-snooping

Note

This command may not be available on all platforms.

This command enables FCoE Initialization Protocol (FIP) snooping traps for the entire switch. When enabled, link traps are sent only if the Link Trap flag setting associated with the port is enabled. show snmp

Default	enabled
Format	snmp-server enable traps fip-snooping
Mode	Global Config

Published February 2019prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback