rmon event

This command sets the RMON event entry in the RMON event MIB group.

Format	rmon event event-number [description string \| log \|owner string \|trap community]
Mode	Global Config

Parameter	Description
event-number	An index that uniquely identifies an entry in the event table. Each such entry defines one event that is to be generated when the appropriate conditions occur. The range is 1 to 65535.
description string	A comment describing the event entry. The default is alarmEvent.
log	Specifies that an RMON log entry should be generated for this event.
ownerstring	Owner string associated with the entry. The default is no owner string.
trap community	The SNMP (Simple Network Management Protocol) community specified by this octet string – used to send an SNMP trap. The default is no community string.

The following shows an example of the command.

(Extreme 220) (Config) # rmon event 1 log description test

Published February 2019prev | next