Use this command to set the detection mode. Detection mode is used to set the type of devices that will be allowed for powering up. You can configure the PoE (Power over Ethernet) controller to detect only IEEE standard devices or pre-IEEE legacy devices (which were pre-standard). Use the no form of the command to bring detection mode back to the default setting of auto.
Default | auto |
Format | poe detection {auto | ieee | pre-ieee} |
Mode | Interface Configuration |
Parameter | Description |
---|---|
auto | Detects both standard and non-standard devices. |
ieee | Detects IEEE standard devices. |
pre-ieee | Detects legacy devices. |