Preface
Using the Command-Line Interface
Stacking Commands
Management Commands
Utility Commands
Switching Commands
Routing Commands
IPv6 Management Commands
Quality of Service Commands
Application Commands
200 Series Log Messages
- Core
- Utilities
- Management
- Switching
- QoS
- Routing/IPv6 Routing
- Stacking
- Technologies
- O/S Support

ip dhcp snooping database write-delay

Use this command to configure the interval in seconds at which the DHCP (Dynamic Host Configuration Protocol) Snooping database will be persisted. The interval value ranges from 15 to 86400 seconds.

Default	300 seconds
Format	ip dhcp snooping database write-delay seconds
Mode	Global Config

Published February 2019prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback