Preface
Using the Command-Line Interface
Stacking Commands
Management Commands
Utility Commands
Switching Commands
Routing Commands
IPv6 Management Commands
Quality of Service Commands
Application Commands
200 Series Log Messages
- Core
- Utilities
- Management
- Switching
- QoS
- Routing/IPv6 Routing
- Stacking
- Technologies
- O/S Support

no application install

This command removes the configuration of an application for execution on the switch. If the application is running, all processes associated with the application are stopped automatically.

Format	no application install filename
Mode	Global Config

For example, to remove the ExtremeCloud application, issue the command:

(Extreme 220) (Config) #no application install connector.pyz

Published February 2019prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback