Preface
Using the Command-Line Interface
Stacking Commands
Management Commands
Utility Commands
Switching Commands
Routing Commands
IPv6 Management Commands
Quality of Service Commands
Application Commands
200 Series Log Messages
- Core
- Utilities
- Management
- Switching
- QoS
- Routing/IPv6 Routing
- Stacking
- Technologies
- O/S Support

snmp-server enable traps multiusers

This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is sent when a user logs in to the terminal interface (EIA 232 or Telnet) and there is an existing terminal interface session.

Default	enabled
Format	snmp-server enable traps multiusers
Mode	Global Config

Published February 2019prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback