Preface
Using the Command-Line Interface
Stacking Commands
Management Commands
Utility Commands
Switching Commands
Routing Commands
IPv6 Management Commands
Quality of Service Commands
Application Commands
200 Series Log Messages
- Core
- Utilities
- Management
- Switching
- QoS
- Routing/IPv6 Routing
- Stacking
- Technologies
- O/S Support

lacp actor port priority

Use this command to configure the priority value assigned to the Aggregation Port for an interface or range of interfaces. The valid range for priority is 0 to 65535.

Default	0x80
Format	lacp actor port priority 0-65535
Mode	Interface Config

Note

This command is applicable only to physical interfaces.

Published February 2019prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback