network protocol dhcp

This command enables the DHCPv4 client on a Network port. If the client-id optional parameter is given, the DHCP (Dynamic Host Configuration Protocol) client messages are sent with the client identifier option.

Default None
Format network protocol dhcp [client-id]
Mode Global Config

There is no support for the no form of the command network protocol dhcp client-id. To remove the client-id option from the DHCP client messages, issue the command network protocol dhcp without the client-id option. The command network protocol none can be used to disable the DHCP client and client-id option on the interface.

The following shows an example of the command.

(Extreme 220) (Routing) # network protocol dhcp client-id