IP Access Control List Commands
This section describes
the commands used to configure IP ACL (Access Control List) settings. IP ACLs
ensure that only authorized users have access to specific resources and block any
unwarranted attempts to reach network resources.
The following rules apply to IP ACLs:
- 200 Series software does not support IP ACL configuration for IP packet fragments.
- The maximum number of ACLs you can create is hardware dependent. The limit applies to all ACLs, regardless of type.
- The maximum number of rules per IP ACL is hardware dependent.
- Wildcard masking for ACLs operates differently from a subnet mask. A wildcard mask is in essence the inverse of a subnet mask. With a subnet mask, the mask has ones (1's) in the bit positions that are used for the network address, and has zeros (0's) for the bit positions that are not used. In contrast, a wildcard mask has (0‘s) in a bit position that must be checked. A 1 in a bit position of the ACL mask indicates the corresponding bit can be ignored.