show flowcontrol

Use this command to display the IEEE 802.3 Annex 31B flow control settings and status for a specific interface or all interfaces. The command also displays 802.3 Tx and Rx pause counts. Priority Flow Control frames counts are not displayed. If the port is enabled for priority flow control, operational flow control status is displayed as Inactive. Operational flow control status for stacking ports is always displayed as N/A.

Format show flowcontrol [unit/slot/port]
Mode Privileged EXEC

The following example shows CLI display output for the command.

(Extreme 220)#show flowcontrol
Admin Flow Control: Symmetric
Port    Flow Control    RxPause    TxPause
        Oper
------  ------------    --------   ---------
0/1     Active          310        611
0/2     Inactive        0           0

The following example shows CLI display output for the command.

(Extreme 220)#show flowcontrol interface 0/1
Admin Flow Control: Symmetric
Port       Flow Control  RxPause      TxPause
           Oper
---------  -------       --------     -------
0/1        Active        310          611