Preface
Using the Command-Line Interface
Stacking Commands
Management Commands
Utility Commands
Switching Commands
Routing Commands
IPv6 Management Commands
Quality of Service Commands
Application Commands
200 Series Log Messages
- Core
- Utilities
- Management
- Switching
- QoS
- Routing/IPv6 Routing
- Stacking
- Technologies
- O/S Support

lacp partner port priority

Use this command to configure the LACP partner port priority. This command can be used to configure a single interface or a range of interfaces. The valid range for priority is 0 to 65535.

Default	0x0
Format	lacp partner port priority priority
Mode	Interface Config

Note

This command is applicable only to physical interfaces.

Published February 2019prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback